Смотрим совсем близко.
Для начала вот спецификация:
- Input power: 11~15V DC /15Amp (at maximum charge rate)
- Charge current: 0.1~8.0A (0.1A/step)Discharger current: 0.1~3.0A (0.1A/step)
- Max. charge power: 150Watt
- Max. discharge power: 15Watt
- Balance charge current: <400mA
- Balance accuracy: <10mV
- Voltage tolerance: 0.10%
- Capacity display: 0~9999mAH
- Supported batteries: 1~6 cells Li-Po, Li-Ion, Li-Mn (2~6 cells in balance charge)
- 1~8 cells LiFePO4 (2~6 cells in balance charge)
- 1~18 cells NiMH, NiCd
- 1~12 cells(2~24V) Pb(SLA)
- Temperature control: Automatically
- PC connection: USB port
- Additional functions: Servo test (Linear, Speed, Deadband)
- DC power supply (3.0~30V DC output)
- Weight: 450g
- Size(LxWxD) 145x100x40mm (5.71"x3.94"x1.57")
Фичи:
1. High power, high current, high-performance power conversion circuit. Maxpro X6-Plus uses advanced DC/DC converter technology with high output conversion efficiency
2. The X6-Plus can be used with four types of Lithium batteries (Li-Po, Li-lon, Li-FePO4, Li-Mn) and has a build-in balancer.
3. Optimized the charging technique of NiMH/NiCd
4. Cooling FAN is controled automaticlly by internal temperature sensor and provides intelligent protection.
5. 16*2 backlit LCD that displays the active mode, battery voltage, charge current, pack temperature, capacity (mAH added or removed) and charge/discharge times.
6. Programmable various charge settings.
Li** batteries: normal chargie, fast charge, balance, storage, discharge, charge/discharge cycle, and battery monitor.
NiMH/NiCd & Pb batteries: charge, discharge, charge/discharge cycle.
7. Perfect protection. The X6-Plus has protection for reversed polarity (input or output), low input voltage, battery temperature, charging capacity and battery voltage overrun.
8. Battery interior resistance measurement with PC monitor software.
9. DC power supply mode can provide 3.0~30V adjustable DC to meet your requirement.
10. Build-in servo tester. Linear, Speed, Deadband of servos can be tested.
11. Firmware upgradable via USB port. The charge/discharge data can be recorded & analyzed by PC monitor software & Battery analyzer software.
Посмотрим что в коробке.
Балансирная колодка под разные разъемы.
Температурный датчик с магнитиком внутри.
УСБ шнурок (А-В)
Сам зарядник с крокодилами.
Универсальный выходной хвост с крокодилами поменьше.
Дисочек с драйверами, софтом и мануалом.
Софт довольно приятный, инфу обновляет раз в 5сек, рисует графики, составляет таблицы, умеет экспортировать их в эксель. Правда к сожалению левый столбец с фирменной рекламой не отключается (или я не нашел где).
Юзер мануал на него.